I was planning on doing 530 lb x 3 for a 3RM, but figured I try this out first. The worst that could happen is I end up not moving the weight, seeing a bunch of stars for a few seconds, and removing plates off the bar in preparation for the next set. Didn't end up going for the 3RM. Saving my thumbs for another day.
Randomly discovered a technical trick with the OHP: place the bar as close to the neck as possible. This moves the bar closer to the line above the midfoot, making it easier to press.
Not bad! Bar leaped off my shoulders on the last rep.
Previous best with this weight was 9 reps.
I'm finding that wearing my belt a little lower at the front makes for better higher rep sets.
Taped the smooth part of the bar to help prevent the bar from sliding off (Actually had this taped on for a while, just haven't been front squatting recently).
However, peeling hard boiled eggs is a huge pain in the ass.
At least it used to be.
I can’t recall making hard boiled eggs myself, so naturally, I thought the process would be super simple and I would master it in no time. I was wrong, and ate a lot of egg shells in the process.
What I would end up doing is boiling the eggs, and when it came time to peel them I would make a huge mess.
Often times when I attempt to remove the egg shells, parts of the shell would come off, but the egg shell membrane would be intact. If I tried to take off the shell and membrane, I'd take off a good chunk of egg white along with it. I would either try to eat the little bits of egg white that was attached to the removed egg shells, or just throw it in the garbage out of frustration.
Sometimes, once I got frustrated enough from trying to peel off the eggshells, is put what is left of the hardboiled eggs and either eat or spit out any of the shells I put in my mouth!
So after getting sick of eating egg shells, naturally I searched online for a way to make “easy peel hard boiled eggs”.
I've tried a variety of different methods online that claim to produce "easy peel hard boiled eggs", ranging from:
Adding vinegar
Adding baking soda
Using a potato masher to pre-crack the eggs
Room temperature eggs first
Cold eggs
Using fresh eggs
Using older eggs
Ice bath after boiling
Put the eggs in the water before boiling
Put the eggs in the water after the water starts boiling
etc, etc.
Using the methods I’ve found, there wasn’t anything that could produce easy to peel hard boiled eggs consistently. The keyword here is consistently.
Some methods would work better than others, but not all the time.
After much experimentation and a lot of egg cartons, I’ve combined some of the methods and come up with the least pain-in-ass way to consistently make hard boiled eggs that's super easy to peel!
Fill the pot with water so that the eggs can be fully submerged.
Turn the stove on high, and allow the water to boil. Do not put the eggs in yet!
Wait until the water boils, then put in the eggs. I normally take the eggs right out of the refrigerator and put it into the boiling water. I’ve only had 1 instance where an egg cracked on me. This can be done with room temperature eggs as well.
Turn the stove to low-medium so that the eggs don’t end up bouncing all over the place and crack prematurely.
Once the timer is up, turn off the heat. Leave the pot on the stove, though.
Use a the edge of the fork to make small cracks in the egg. You can also use a spoon, but I find I have better control with the flat fork than a curved spoon.
Then, use the bottom (flat part of the fork) and gently press down to create more cracks. Do can press and roll the egg. The more cracks the better. Be careful not to squish the egg!
Removing the shells at this point should be super easy. If the above steps are done properly, the egg shell should come off along with that clear film lining an eggshell (egg shell membrane).